Discussion area for the 2.8 liter 12-valve VR6 motor.
So why choose flightpower when you want to fly cheap? The reason is because.it comes with with 2 JR output leads. So I have no need to buy 2 pairs of deans and resolder which will make other cheaper packs at least as expensive. Also, I had pretty bad luck with those cheap china lipo when I first started out with electric flight during those 8c lipo days.
1320mah for the light weight. Its good for 4 flight max, but I do 3 so I can land with ample reserve. In any case, I usually only do 3flight per trip to the field, unless its really a nice day.
. FC450 FC450 Flight Control System Instruciton Manual FC450四旋翼飞行控制器 Shanghai Dualsky Models co.,Ltd.
Rm.1016,No.201,Xin Jin Qiao Rd.,Shanghai,China. 使用说明书 Tel: +2162 Fax: +2163 #21050 Made in China 21ZX13E1720 ww.dualsky.com.
(b) Shockproof double sided tape x 1 (d) Standard signal wire x 2 must be the same as the following diagram 1 or 2. (Please make sure to use the double sided tape comes with FC450 to mount it on frame.) 21021-1 (.
Diagram 2 (Cross Type) 3. FC450 supports 4.8V-7.4V input voltage. Since it shares the same Head Direction input power with the receiver, the input voltage must also meet the requirements of the receiver. A) When use external power supply, please cut the ESC BEC output like Diagram 4. Rate ELEVATOR Configuration THROTTLE ● The FC450 needs a 4-channel or higher radio controller to operate; RUDDER If you are using a 5-channel or higher radio controller, please sign CH5/GEAR a 3-position or 2-position switch on the radio to CH5/GEAR Diagram 6 channel and make sure the switch doesn’t have other function, set.
ESC Initial Setting Before install FC450, please finish the ESC initial setting. Make sure ESCs and FC450 have the same stroke setting.If you use Dualsky ESC, you can set all ESCs after FC450 installation by the following steps: ● Turn on the radio controller, push the throttle stick to the top, turn on power to the quadcopter, when L1 shows blue in color, it means the ESC is in initial setting mode. ● Turn on the radio, pull the throttle stick to lowest position, plug in Ground Test the power to the quadcopter.
L1 LED on FC450 Flight Control will ● Set all sensitivity potentiometers on FC450 to neutral. Flash Green (initial startup process), don't move sticks on the radio ●. ● The channel center point can differ depending on the choice of radio brand, the installation of FC450 can also cause deviation. If the quadcopter has deviation after take off, please adjust the trim on radio to find the center position. FC450 FC450四旋翼飞行控制器 使用说明书 上海双天模型有限公司 Tel: +2162 Fax: +2163 #21050 - 13 -14.